Gauging Interest COP
I have the ability to manufacture a smaller quantity of Coil On Plug setups but want to gauge interest prior to spending the money on getting the plates made. I will be using slightly used Coils with brand new plates, wiring and boots. The price for these setups will be $125 and will be tested to make sure they work. If there is enough interest and the right prepurchased quantity I will go through with it. Either reply to this thread or pm me if interested.
454 whp/440 ft/lbs torque on an evo 16g, pump gas, methanol injection, AEM EMS, stock cam timing, closed 2.5" exhaust, Tuned by Beyond Redline
Harvey, I would be interested in one for my GVR4.
I know your quality, and it is a screaming price for specifically that!
As for the coils, those are the 300M (Seabring) ones right?
If the wiring is nice, and the polishing is your "normal", I know I will be impressed!
Give me a call when you are ready to go forward.
Tim Zimmer
1999 Mitsubishi Eclipse GSX
7-Bolt 2.3L Stroker, BW S475, AEM EMS
*779AWHP/602 TQ at partial run on 41psi with new turbo on 8/21/2009.
*766AWHP/716 TQ Highest numbers on GT4088R in 2008.
*9.961 @ 143.33mph w/ 641WAHP/567TQ with GT4088R on 9/16/2007.
*Only Tuned / Dyno'ed by Beyond Redline Performance and TMZ Performance.
---------------------------------------------
1992 Nile Black Mitsubishi Galant VR-4 957/1000 Winter Beater
count me in.
Note that these plates will not be polished but very nicely sanded. Polishing can be done at an additional $20. Mind you that $20 polish job with my quality is cheap.
454 whp/440 ft/lbs torque on an evo 16g, pump gas, methanol injection, AEM EMS, stock cam timing, closed 2.5" exhaust, Tuned by Beyond Redline
What about powder coating in black?!
1991 Eagle Talon TSi AWD - White
1990 Eagle Talon TSi AWD - Champagne
It's in the Media forum afterall.
11.30 @ 128
'92 Integra GS - "Dirty DA9"
'03 Civic Si - JDM Daily Driver Project
I was gonna say, do you have any pics? I think I remember you selling these a while back, but not sure.
Anywho i want one of these, What are the limits of a COP setup?
The reason there aren't any pictures is because I have not had any plates made. I didn't want to spend the money if nobody was interested and there I sat with COP setups and I am out the money.
As far as the limitations of a COP I am unsure but I do know the Tim Zimmer is running one and he is making a boat load of power.
This will be the first time I have ever tried selling COP's on here as well. JSpec was the guy.
As for powder coating I can see what it would cost me. If there is a serious interest for at least 5 of these I will go ahead and get the plates coming.
454 whp/440 ft/lbs torque on an evo 16g, pump gas, methanol injection, AEM EMS, stock cam timing, closed 2.5" exhaust, Tuned by Beyond Redline
will you be able to make a 90 plug work? i know my 90 ignition plug is different than 91 and up.... just wondering
My apologies for the mix up, well I don't plan on getting that crazy with my car.
So i should be good.
A pic of what it would look like would be cool though.
Any kind of warranty/guarantee.
Posting Permissions
Reply With Quote
